Urban Renewal Cage Wall Light, Crook Arm, Dark Antique Brass

Workshop cage and curved arm

The round wall backplate, 14 cm in diameter, carries a tube that rises and then curves forward like a walking stick. At the end, the lampholder hangs inside a cage made of thin vertical rods held by two rings; a ring closes the cage beneath the bulb. The slightly shaded dark antique brass finish recalls the old industrial lamps that inspired the range.

Visible bulb, direct light

A single E27 lampholder, 60 W maximum, supplied without bulb. The cage does not hide the light source: choose a decorative filament LED, preferably in warm white. The light can be dimmed when used with a dimmable bulb. IP20: to be installed in a room protected from moisture.

Projection and mounting height

Allow for 31.1 cm in height and 19.7 cm of projection from the wall: leave some clearance in a narrow passage. It weighs 1.53 kg and, being Class I, must be connected to earth. Mounting it at about 1.60 to 1.80 m from the floor puts the cage at eye level; in that case, choose a low-wattage bulb to limit glare.